Where is the CMP sensor located?

Table of Contents

Beneath the timing belt cover is where the CMP Sensor is mounted. The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.

What is a CMP sensor Honda?

Refine Results. 2023. 2022. A camshaft position sensor helps the engine control unit (ECU) determine the precise amount of fuel the engine needs at any given moment.

Where is the cam sensor located on a Honda Civic?

Re: Camshaft Position Sensor Location “If you have the hood up, facing the engine, it is just to the right of the valve cover, underneath (closer to the ground) and behind (inset an inch or so) the timing belt cover. The sensor is oriented so that oval female connector it is facing the driver’s side wheel.

What does a CMP sensor detect?

Depending on your particular vehicle model, the ECM (electronic control module or car computer) may use the CMP sensor to synchronize and sequence fuel injectors and/or set direct ignition timing.

What is a camshaft position actuator circuit open bank 2?

Diagnostic Trouble Code (DTC) P0020 stands for “Intake “A” Camshaft Position Actuator Circuit / Open (Bank 2).” It is triggered when the powertrain control module (PCM) detects that the voltage from the variable valve timing circuit has fallen out of specification for a calibrated amount of time.

How do you change a camshaft sensor?

How to Change a Camshaft Position Sensor

Locate the camshaft sensor.
Disconnect the electrical plug on the sensor by pressing on the tab and pulling it off.
Insert the new cam sensor, making sure to keep the tip clean.
Rotate the sensor to align the hole in the bracket with that of the mounting surface.

Is a cam sensor the same as a crank sensor?

The main difference between camshaft and crankshaft position sensors is that the camshaft position sensor is used to find the position of the camshaft while the crankshaft position sensor is used to detect the position of the crankshaft and piston.

What causes a camshaft sensor to fail?

There are many reasons why the camshaft position sensor could fail. Some of these include wear-and-tear, water damage, and oil embedded in the engine. There are also sensors that fail due to corrosion, which is a common problem for camshaft position sensor circuits.